RIGIPS® 4PRO Plasterboard

Type A (GKB) plasterboard, 12,5 mm thick, with four flattened PRO edges.

The 4PRO™ technology is the only solution on the market that makes it possible to create walls/ceilings of the highest degree of smoothness, while shortening the work time and significantly reducing the use of filling compounds. The effect is achieved thanks to PRO technology on all 4 edges, allowing for instant assembly, eliminating the need for cutting transverse joints, ensuring no thickening at the joints, providing the same strength as longitudinal joints, the same appearance, great savings in mass and time, and the possibility of making longitudinal and transverse joints in one step. In the case of full-surface mudding, a much thinner layer of material is required.

Advantages of RIGIPS® 4PRO boards:

• Easy navigation on the board. The dots in the middle of the board make it easier to install the boards with the profile spacing of 60 cm, and the dotted lines placed in 1/3 and 2/3 of the board make it easier to install the boards with the profile spacing of 40 cm.
• 4PRO boards enable all joints, including transverse joints, to be made using the same technology. This results in: maximum strength, highest smoothness of finish, time and material savings.
• Quick and precise installation made possible by the printed measuring tape along the edge of the board.
• Small PRO edge depth (1 mm).
• Maximum strength of the joint between plasterboards thanks to optimum placement of the joint tape (less risk of cracks).
• 1-fold structural mudding of the joint between plasterboards with the use of a joint tape, due to imperceptible shrinkage of the binding and drying mass (low thickness of joint compound).
• Reduced consumption of joint compound needed to make a joint between plasterboards, resulting in savings in the costs of purchasing materials.
• Shorter time needed to achieve a ready joint due to faster drying of a thin layer of joint compound.
• Freedom of plasterboard installation using sheet metal screws (screws even 10 mm from the board edge).
• Easy control of planes created at the joint between two plasterboards.
• Easy control of planes created at the joint between two plasterboards.

Application

• Suspended ceilings
• Ceiling linings
• Attic cladding
• Wall covering
• Partition walls

Recommended for rooms with high aesthetic requirements, where there are large, intensively lit surfaces, especially where there are cross-edge joints.

Technical parameters